About A470 Soaring


This is the blog for a few guys who spend their time flying radio controlled gliders, or slope soarer's, from the many and varied slopes around SE Wales.

This usually begins at the northern end of Cardiff, driving north up the A470 up to the Heads of the Valley's and the southern fringe of the Brecon Beacons. But the A470 road continues its windy way all the way to N Wales.

There are many slopes available for most wind directions, the most famous being the area between Nant-y-Moel and Treorchi known as The Bwlch, which has some of the best slopes and flying in Europe with many F3F competitions being held there each year and visited by many fliers from Europe and around the world. At 1500 feet (450m) above sea level, there is usually more wind than not, and certainly more than at sea level.

If you require any further information, are new to slope soaring or are visiting the area, please contact Steve at steve.houghton59@gmail.com . I look forward to hearing from you.

Take a look at Page 2 (look below and to the left here) for Google maps of our most popular Flying Sites.


Tuesday 26 January 2016

Build Blog of my 1350mm span Correx sheet ME - 109.

By Phil May

This build is going to hold a few more challenges than my previous correx builds, mainly because the plan I'm using is not the usual 'unwrapped ' fuselage and wing type but a conventional one.

Also I am going to build the fuselage out of 2mm sheet instead of my usual 4mm. The reason for this is to try to reduce weight of the finished model. First off I glued the plans of the formers onto 4mm correx and carefully cut these out using a sharp craft knife, ensuring the blade was kept vertical at all times. I then used coarse sandpaper where necessary to get the correct shape. A 10mm hole was then drilled at the pre-marked centre spot. All the formers were then slide onto a length of 10mm diameter wooden dowel and lined up as per plan....This ensures that the fuselage is going to be build straight and true.


This is the plan I'm working off.




Former plans glued onto 4mm Correx sheet



   Formers are pushed on to wooden dowel



Posted by

1 comment:

  1. Unknown26 January 2016 at 13:35

    It will be good to watch this one take shape Phil.

    ReplyDelete

Subscribe to: Post Comments (Atom)